123D Catch


123D Catch
#1
I noticed this (free, at least at the moment) photo-based 3D scanner from Autodesk:

http://www.123dapp.com/catch

I wonder if it's accurate enough to use for part creation, and, if so, if there's any way to get from its file format into LDraw format.
Reply
Re: 123D Catch
#2
I'll have a closer look on this! On the main page, they say the mesh can be exorted to .obj, so there should be no problem to convert to LDraw.
Reply
Re: 123D Catch
#3
Tried today... complete failure so far!
And if only there was a WRITTEN manual instead of those pesky videos Sad
Reply
« Next Oldest | Next Newest »



Forum Jump:


Users browsing this thread: 1 Guest(s)