+- LDraw.org Discussion Forums (https://forums.ldraw.org)
+-- Forum: Models and Parts (https://forums.ldraw.org/forum-18.html)
+--- Forum: Parts Authoring (https://forums.ldraw.org/forum-19.html)
+--- Thread: 123D Catch (/thread-4917.html)
123D Catch - Travis Cobbs - 2012-05-15
I noticed this (free, at least at the moment) photo-based 3D scanner from Autodesk:
http://www.123dapp.com/catch
I wonder if it's accurate enough to use for part creation, and, if so, if there's any way to get from its file format into LDraw format.
Re: 123D Catch - Philippe Hurbain - 2012-05-16
I'll have a closer look on this! On the main page, they say the mesh can be exorted to .obj, so there should be no problem to convert to LDraw.
Re: 123D Catch - Philippe Hurbain - 2012-05-19
Tried today... complete failure so far!
And if only there was a WRITTEN manual instead of those pesky videos
