LDCad Part Snapping missing/errors


RE: Part Snapping missing/errors
For the partĀ "Technic Sprocket Wheel 25.4" (57520), the following places snap points forĀ each of the sprocket notches. That in turn makes placing the chain tread (57518) somewhat less fraught.


0 !LDCAD SNAP_CLP [radius=4] [length=10] [center=true] [slide=true] [pos=0 -30 0] [ori=-1 0 0 0 0 1 0 -1 0]
0 !LDCAD SNAP_CLP [radius=4] [length=10] [center=true] [slide=true] [pos=0 30 0] [ori=1 0 0 0 0 -1 0 -1 0]
0 !LDCAD SNAP_CLP [radius=4] [length=10] [center=true] [slide=true] [pos=-25.980762 -15 0] [ori=-1 0 0 0 0 -1 0 -1 0]
0 !LDCAD SNAP_CLP [radius=4] [length=10] [center=true] [slide=true] [pos=-25.980762 15 0] [ori=1 0 0 0 0 -1 0 -1 0]
0 !LDCAD SNAP_CLP [radius=4] [length=10] [center=true] [slide=true] [pos=25.980762 -15 0] [ori=-1 0 0 0 0 -1 0 -1 0]
0 !LDCAD SNAP_CLP [radius=4] [length=10] [center=true] [slide=true] [pos=25.980762 15 0] [ori=1 0 0 0 0 -1 0 -1 0]


David
Reply
« Next Oldest | Next Newest »



Messages In This Thread
RE: Part Snapping missing/errors - by David Manley - 2022-02-24, 4:04

Forum Jump:


Users browsing this thread: 1 Guest(s)