2019-12-31, 2:30
This is intended to be a catchall thread to let Roland know about missing/problematic part snapping info.
Note: make sure that the part you are reporting is official
Note: make sure that the part you are reporting is official
0 !LDCAD SNAP_CYL [gender=F] [caps=one] [secs=R 6 12] [pos=0 39 -140]
0 !LDCAD SNAP_CYL [gender=F] [caps=one] [secs=R 6 12] [pos=0 39 140]
0 !LDCAD SNAP_CYL [group=axleR4] [gender=F] [caps=none] [secs=R 4 80] [pos=-40 42 -100] [ori=0 -1 0 1 0 0 0 0 1]
0 !LDCAD SNAP_CYL [group=axleR4] [gender=F] [caps=none] [secs=R 4 80] [pos=-40 42 100] [ori=0 -1 0 1 0 0 0 0 1]
0 !LDCAD SNAP_CYL [gender=F] [caps=one] [secs=S 6 4] [pos=-50 8 -150] [grid=2 16 100 20]
0 !LDCAD SNAP_CYL [gender=M] [caps=one] [secs=R 6 12]
0 !LDCAD SNAP_GEN [group=mag] [gender=M] [bounding=pnt] [match=group] [pos=56 -5 0]
0 !LDCAD SNAP_GEN [group=mag] [gender=F] [bounding=pnt] [match=group] [pos=56 -5 0] [ori=-1 0 0 0 1 0 0 0 -1]
0 !LDCAD SNAP_CYL [group=axleR4] [gender=M] [caps=none] [secs=R 4 80] [pos=-40 0 0] [ori=0 -1 0 1 0 0 0 0 1]
(2019-12-31, 2:30)Orion Pobursky Wrote: [ -> ]This is intended to be a catchall thread to let Roland know about missing/problematic part snapping info.Good idea.
(2020-01-02, 2:06)Orion Pobursky Wrote: [ -> ]60478.dat, Plate 1x2 with Handle on End. Mirror doesn't work correctly. Probably missing infoThat one isn't symmetrical in the X direction. Mirroring only works without shadow info for parts that are x symmetric.
0 !LDCAD MIRROR_INFO [baseFlip=Z]
0 !LDCAD SNAP_CLEAR [ID=axleHole]
0 !LDCAD SNAP_CYL [gender=F] [caps=one] [secs=A 6 20] [pos=0 30 0] [ori=-1 0 0 0 1 0 0 0 -1]