LDCad Part Snapping missing/errors

RE: Part Snapping missing/errors
(2021-10-01, 17:10)N. W. Perry Wrote: Good question…I am not fortunate enough to have owned the set these parts came in (but can you guess what I've been building?). But while 2907 is meant to rotate on XZ along with 2999, it is also meant to pivot independently on XY. So perhaps snapping is not recommended?
I think it can snap: this is the same kind of joint type as 32494/92906.
« Next Oldest | Next Newest »

Messages In This Thread
RE: Part Snapping missing/errors - by Philippe Hurbain - 2021-10-01, 18:04
RE: Part Snapping missing/errors - by SNIPE - 2022-07-22, 13:59

Forum Jump:

Users browsing this thread: 1 Guest(s)