LDCad Part Snapping missing/errors


RE: Part Snapping missing/errors
#94
(2021-10-01, 7:54)Max Martin Richter Wrote: The hub is free movable in the arm without the wheel. But it should snap to its final position in LDCad, I think.
The wheel can be connected in one way only. It's not possible to connect it with the backside turned to the outside.

The arm is 6540a/b, by the way. I did check the fit of all three parts, and with the 0 11 0 position on the wheel rim, everything lines up snugly.
Reply
« Next Oldest | Next Newest »



Messages In This Thread
RE: Part Snapping missing/errors - by N. W. Perry - 2021-10-01, 17:05
RE: Part Snapping missing/errors - by SNIPE - 2022-07-22, 13:59

Forum Jump:


Users browsing this thread: 1 Guest(s)