LDCad Part Snapping missing/errors


RE: Part Snapping missing/errors
#92
(2021-10-01, 2:05)N. W. Perry Wrote: The numbers are mixed up…but this is what works for me:

2998a.dat
Code:
0 !LDCAD SNAP_GEN [group=techWhlCon1] [gender=F] [bounding=cyl 17 23] [ori=0 0 -1 1 0 0 0 -1 0]

Position should stay at 0 0 0, and there doesn't seem to be a need for the second snap. This wheel only seems to fit one way.

2999.dat
Code:
0 !LDCAD SNAP_CYL [gender=M] [caps=none] [secs=R 23 3   R 20 4   R 18 56   _L 19 2] [slide=true] [pos=0 -31 0] [ori=0 0 1 0 -1 0 1 0 0]
0 !LDCAD SNAP_GEN [group=techWhlCon1] [gender=M] [bounding=cyl 17 23] [pos=0 11 0]

This is fine with the pos adjusted to 0 11 0. (The original was 0 12 0 and was off by 1 LDU.)

The hub is free movable in the arm without the wheel. But it should snap to its final position in LDCad, I think.
The wheel can be connected in one way only. It's not possible to connect it with the backside turned to the outside.
Reply
« Next Oldest | Next Newest »



Messages In This Thread
RE: Part Snapping missing/errors - by Max Martin Richter - 2021-10-01, 7:54

Forum Jump:


Users browsing this thread: 1 Guest(s)