LDCad Part Snapping missing/errors


RE: Part Snapping missing/errors
#45
(2020-07-09, 2:50)N. W. Perry Wrote: So yeah, it's meant to just go onto wpin.dat. The wheel pin clicks into the empty space in the middle, so it only extends halfway through the wheel.

Here's what I ended up going with:

Code:
0 !LDCAD SNAP_CYL [gender=F] [caps=none] [secs=R 4 11   R 5 3   R 4 11] [center=true] [slide=true] [ori=1 0 0 0 0 1 0 -1 0]

Yes, but on both sides.

This rim should have used 2 wpinhol2
1 16 0 0 -3.25 -0.707107 0 -0.707107 -0.707107 0 0.707107 0 9.25 0 wpinhol2.dat
1 16 0 0 3.25 -0.707107 0 -0.707107 -0.707107 0 0.707107 0 -9.25 0 wpinhol2.dat
Reply
« Next Oldest | Next Newest »



Messages In This Thread
RE: Part Snapping missing/errors - by Magnus Forsberg - 2020-07-09, 5:20
RE: Part Snapping missing/errors - by SNIPE - 2022-07-22, 13:59

Forum Jump:


Users browsing this thread: 2 Guest(s)