[LDCad] Part Snapping missing/errors

[Roland Melkert]

For the part "Technic Sprocket Wheel 25.4" (57520), the following places snap points for each of the sprocket notches. That in turn makes placing the chain tread (57518) somewhat less fraught.

Very useful, I added:

Code:

0 !LDCAD SNAP_CLP [radius=4] [length=10] [center=true] [pos=0 -30 0] [ori=-1 0 0 0 0 1 0 -1 0]
0 !LDCAD SNAP_CLP [radius=4] [length=10] [center=true] [pos=25.980762 -15 -0] [ori=-0.5 -0 -0.866025 -0.866025 -0 0.5 0 -1 0]
0 !LDCAD SNAP_CLP [radius=4] [length=10] [center=true] [pos=25.980762 14 -0] [ori=0.5 -0 -0.866025 -0.866025 -0 -0.5 0 -1 0]
0 !LDCAD SNAP_CLP [radius=4] [length=10] [center=true] [pos=0 30 0] [ori=1 0 0 0 0 -1 0 -1 0]
0 !LDCAD SNAP_CLP [radius=4] [length=10] [center=true] [pos=-25.980762 14 -0] [ori=0.5 0 0.866025 0.866025 -0 -0.5 -0 -1 0]
0 !LDCAD SNAP_CLP [radius=4] [length=10] [center=true] [pos=-25.980762 -15 -0] [ori=-0.5 0 0.866025 0.866025 -0 0.5 -0 -1 0]

to s\57520s02.dat

Only difference with yours are the clip orientations which may come into play in a future version of the snapping engine.