LDCad Part Snapping missing/errors


RE: Part Snapping missing/errors
#47
I have no idea if this is my fault or maybe I missed something, but perhaps it has to do with part snapping: using 35563 (Cone 4x2x4 Half with Roof Tiles, I think it was in the last LDraw part update) as upper part and trying to snap this with the bottom to the upper side of a below 48310 (Cone 8x4x6 Half), the part is 1/2 stud (10 LDU) beside the "real" studs..
Reply
« Next Oldest | Next Newest »



Messages In This Thread
RE: Part Snapping missing/errors - by Stefan Frenz - 2020-07-09, 18:23

Forum Jump:


Users browsing this thread: 1 Guest(s)