LDCad Part Snapping missing/errors


RE: Part Snapping missing/errors
#46
(2020-07-09, 5:20)Magnus Forsberg Wrote: Yes, but on both sides.

Well, the single cyl snap extends all the way through. A wheel pin will snap on either side, but a 318 bar will still slide all the way through. But perhaps this is not the preferred method?

Quote:This rim should have used 2 wpinhol2
1 16 0 0 -3.25 -0.707107 0 -0.707107 -0.707107 0 0.707107 0 9.25 0 wpinhol2.dat
1 16 0 0 3.25 -0.707107 0 -0.707107 -0.707107 0 0.707107 0 -9.25 0 wpinhol2.dat

The geometry of the rim is funky overall, and doesn't match the wpin's dimensions well. Maybe the snap info should match the rim's geometry rather than the pin's, allowing some realistic "play", but in my models I find that more a hindrance than a help. I like things like wheels to just snap to one place, and one place only.
Reply
« Next Oldest | Next Newest »



Messages In This Thread
RE: Part Snapping missing/errors - by N. W. Perry - 2020-07-09, 17:17

Forum Jump:


Users browsing this thread: 1 Guest(s)