[LDCad] Part Snapping missing/errors

[Roland Melkert]

4x4 Dome (86500.dat) has no info. I put anti-studs at all four corners (under the notches), but I'm not sure that's the right approach. You may need more studs inside the rim, or maybe the whole thing has to act as one giant cylinder snap?

The corners is probably good enough.

I've also added the ring, so if something happens to use the same radius it will snap to that too.

Code:

0 !LDCAD SNAP_CYL [gender=F] [caps=one] [secs=R 6 4] [grid=C 2 C 2 60 60]
0 !LDCAD SNAP_CYL [gender=F] [caps=A] [secs=R 38 4] [pos=0 -4 0] [ori=1 0 0 0 -1 0 0 0 -1]
0 !LDCAD SNAP_CYL [gender=M] [caps=one] [secs=R 39.5 4] [pos=0 -4 0] [ori=1 0 0 0 -1 0 0 0 -1]