(2017-06-07, 9:00)yongxu wang Wrote: I installed stl2datThen you must use a command line prompt. But it you are not comfortable with this, install LETGUI instead!
Quote:Don't forget to model using LDUs rather than mm or inches.Note: 1ldu = 0.4mm
| Messages In This Thread |
|
Part 71981,6182721,6073604,2214…… - by yongxu wang - 2017-06-06, 5:38
RE: Part 71981,6182721,6073604,2214…… - by Philippe Hurbain - 2017-06-06, 8:48
RE: Part 71981,6182721,6073604,2214…… - by yongxu wang - 2017-06-06, 15:20
RE: Part 71981,6182721,6073604,2214…… - by Willy Tschager - 2017-06-06, 16:49
RE: Part 71981,6182721,6073604,2214…… - by Philippe Hurbain - 2017-06-06, 18:56
RE: Part 71981,6182721,6073604,2214…… - by yongxu wang - 2017-06-07, 4:55
RE: Part 71981,6182721,6073604,2214…… - by Philippe Hurbain - 2017-06-07, 6:59
RE: Part 71981,6182721,6073604,2214…… - by yongxu wang - 2017-06-07, 9:00
RE: Part 71981,6182721,6073604,2214…… - by Philippe Hurbain - 2017-06-07, 11:02
|
