(2017-02-07, 17:53)Merlijn Wissink Wrote: I just tried this in LDcad and they look perfectly fine here. No problems whatsoever...Both are perfectly aligned here too. But if you look at 32028.dat you see "0 !HISTORY 2009-01-02 [anathema] Corrected dimensions of tongue, optimised a bit", so... are you sure that your library is fully up to date?
LDraw.org Discussion Forums
›
Models and Parts
›
Parts Authoring
Parts that do not quite fit together
Parts that do not quite fit together
Parts that do not quite fit together
« Next Oldest | Next Newest »
| Messages In This Thread |
|
Parts that do not quite fit together - by Christian Maglekær - 2017-02-07, 16:05
RE: Parts that do not quite fit together - by Merlijn Wissink - 2017-02-07, 17:53
RE: Parts that do not quite fit together - by Philippe Hurbain - 2017-02-07, 18:39
|
Users browsing this thread: 1 Guest(s)