LDraw.org Discussion Forums

LDraw.org Discussion Forums > Models and Parts > Parts Authoring > Parts that do not quite fit together
Full Version: Parts that do not quite fit together
You're currently viewing a stripped down version of our content. View the full version with proper formatting.

Christian Maglekær

2017-02-07, 16:05
Hi there.

I noticed that the plate 1x2 with Door rail and plate 1x8 with Door rail. Has not the same thickness on rail.


https://dl.dropboxusercontent.com/u/2570...20rail.gif

Merlijn Wissink

2017-02-07, 17:53
I just tried this in LDcad and they look perfectly fine here. No problems whatsoever...

Philippe Hurbain

2017-02-07, 18:39
(2017-02-07, 17:53)Merlijn Wissink Wrote: [ -> ]I just tried this in LDcad and they look perfectly fine here. No problems whatsoever...
Both are perfectly aligned here too. But if you look at 32028.dat you see "0 !HISTORY 2009-01-02 [anathema] Corrected dimensions of tongue, optimised a bit", so... are you sure that your library is fully up to date?
LDraw.org Discussion Forums > Models and Parts > Parts Authoring > Parts that do not quite fit together