finding part


finding part
#1
Evening all would like some help i want a flex-system hose that i can bend how i want the one i have circled is normal i can not bend the one on far left is too big where or is there one thanks for help


Attached Files Thumbnail(s)
   
Reply
RE: finding part
#2
(2022-12-20, 22:06)Sparky678911 Wrote: Evening all would like some help i want a flex-system hose that i can bend how i want the one i have circled is normal i can not bend the one on far left is too big where or is there one thanks for help

You may want to use a template via the parts bin, as follows:

[Image: template_select_flexible.jpg]

in conjunction with reading the section titled "Dynamic Parts" on Roland's Advanced Editing webpage.
Reply
RE: finding part
#3
thanks for reply but on mine for some reason they look strange not the same as yours Huh


Attached Files Thumbnail(s)
   
Reply
RE: finding part
#4
(2022-12-21, 19:07)Sparky678911 Wrote: thanks for reply but on mine for some reason they look strange not the same as yours Huh

Looks like you're missing a valid search location for Donors. You can check under Prefs->LDraw->Search (library) paths…

Is there an entry for Donors there?
Reply
RE: finding part
#5
this is what i have in there


Attached Files Thumbnail(s)
   
Reply
RE: finding part
#6
(2022-12-22, 18:39)Sparky678911 Wrote: this is what i have in there

Ah, it's showing as an Unofficial library rather than Donors. Try choosing the "donors" type option (the row of buttons), then re-launch LDCad and see if it's better.
Reply
RE: finding part
#7
Big Grin perfect thank you
Reply
« Next Oldest | Next Newest »



Forum Jump:


Users browsing this thread: 1 Guest(s)