Hi everyone,
I have a flexible hose already placed in my model, complete with bends and curves. I've also built a small ring-shaped assembly (grouped as a sub-model) that is sized to fit snugly around the hose — for simplicity, let's say I could reduce it to a single Technic Brick 2×1 with Hole (3700).
What I'd like to achieve is essentially an array along a curve: repeat that brick or sub-model N times at regular intervals along the hose, so that each instance follows the hose's orientation at its respective position — i.e., it inherits the local rotation of the hose segment it sits on.
Think of it like cable clamps or spacer rings distributed evenly along a hydraulic line or wiring harness.
Does LDCad have any built-in feature that allows this, or is it achievable through a Lua script?
Any pointers — tools, scripts, workflows, or even manual tricks — would be greatly appreciated. Thanks in advance!
I have a flexible hose already placed in my model, complete with bends and curves. I've also built a small ring-shaped assembly (grouped as a sub-model) that is sized to fit snugly around the hose — for simplicity, let's say I could reduce it to a single Technic Brick 2×1 with Hole (3700).
What I'd like to achieve is essentially an array along a curve: repeat that brick or sub-model N times at regular intervals along the hose, so that each instance follows the hose's orientation at its respective position — i.e., it inherits the local rotation of the hose segment it sits on.
Think of it like cable clamps or spacer rings distributed evenly along a hydraulic line or wiring harness.
Does LDCad have any built-in feature that allows this, or is it achievable through a Lua script?
Any pointers — tools, scripts, workflows, or even manual tricks — would be greatly appreciated. Thanks in advance!