Hi guys! In August we get some new technic parts, I already have two of them in my 42173 Koenigsegg and I would ask to make them in digital form.
The first one is the frame 3x13 - it is basically the shorter version of the previous longer, so I think it should be easy to do:
Next one is the cuved panel 3x9 - slightly different than 3x11 but here are the key differences:
The outside parts is smooth, there is no "grille" anymore, on the opposite there are 4 small dots:
When you compare them both in the middle, you can see the both parts have the same height:
And it fits to the mudguard 2459:
The part numbers are visible, I hope there are possible to read:
But if not,
Frame: 4526
Panel: 5427
Thanks in advance!
The first one is the frame 3x13 - it is basically the shorter version of the previous longer, so I think it should be easy to do:
Next one is the cuved panel 3x9 - slightly different than 3x11 but here are the key differences:
The outside parts is smooth, there is no "grille" anymore, on the opposite there are 4 small dots:
When you compare them both in the middle, you can see the both parts have the same height:
And it fits to the mudguard 2459:
The part numbers are visible, I hope there are possible to read:
But if not,
Frame: 4526
Panel: 5427
Thanks in advance!
