Request for vintage tail bb96 (bb0096)

[Geske]

Hi there,

is there an advanced part designer who can provide for use in Studio the 
Vintage tail bb96

I'm missing it badly for a MOC, but I haven't the talent to design parts.

In most cases this part originates in set 698-1.
I varied a badly yellowed one of them by painting it in yellow and
attached a „condor“ decal on it.

[Rene Rechthaler]

the tail itself looks a lot like 4867.dat
https://library.ldraw.org/official/9749
but what about the base? does anyone own that part for good pictures /measurements?
does a 1x1 roundbrick fit to the round air inlet at the front?

[Javier Orquera]

but what about the base? does anyone own that part for good pictures /measurements?
does a 1x1 roundbrick fit to the round air inlet at the front?

Hello: I found the following video https://youtu.be/C0Yhepz7n64?feature=shared. Hope it helps on the model design.

[Geske]

the tail itself looks a lot like 4867.dat
https://library.ldraw.org/official/9749
but what about the base? does anyone own that part for good pictures /measurements?
does a 1x1 roundbrick fit to the round air inlet at the front?

I own three of these and can deliver measurements tonight. Actually the front hole is bigger than a standard stud. So nothing can be fixed here. Also the length and width is unusual.
I will add photos later today. 

All the best
Anselm

[Geske]

the tail itself looks a lot like 4867.dat
https://library.ldraw.org/official/9749
but what about the base? does anyone own that part for good pictures /measurements?
does a 1x1 roundbrick fit to the round air inlet at the front?

Here are my measurements for part bb96:

[Geske]

More measurements:

[Gerald Lasser]

Do you have a picture from above and especially below (anti-studs)?

and the measurements of the body width.

[Geske]

Do you have a picture from above and especially below (anti-studs)?

and the measurements of the body width.

Yes, some pictures got lost somehow. Here they are:

[Takeshi Takahashi]

The part number will be u405.
http://www.peeron.com/inv/parts/x405

I'm also looking forward to seeing this part on LDraw and creating JAL jetliner (set 698).