[Complete] New Speed Champion windscreen 80222

[Nathan S]

Has anyone taken a look yet at the new windscreen 80222? It has some angles that offer great possibilities.  Thank you.

https://www.bricklink.com/v2/catalog/cat...6#T=C&C=86

[Nathan S]

Has anyone taken a look yet at the new windscreen 80222? It has some angles that offer great possibilities.  Thank you.

https://www.bricklink.com/v2/catalog/cat...6#T=C&C=86

No takers?

[Magnus Forsberg]

No takers?

This one is more difficult. I need to have the part and study the dimensions.

[Nathan S]

This one is more difficult. I need to have the part and study the dimensions.

No doubt.  I was hoping the new 1874 was going to be similar, but no similar angles from what I can see.  The only thing I can see similar is that 18973 does seem to be the same angle as the center four studs width of 80222.

[Philippe Hurbain]

This one is more difficult. I need to have the part and study the dimensions.

This part is in LEGO instructions. But not home to extract it😁

[Magnus Forsberg]

This part is in LEGO instructions. But not home to extract it😁

You can send it to me, when you got it.

[Philippe Hurbain]

You can send it to me, when you got it.

Sure, but may be long... Perhaps Gerald would be faster 😁

[Gerald Lasser]

gett back to the full environment again :-)

Here is the raw part, with one side having cond lines only (coversion created the edge lines)

I played around with the TEXMAP for the patterned version but never made the part itsef ready for the PT

[Magnus Forsberg]

Now on the Part Tracker



https://www.ldraw.org/cgi-bin/ptdetail.c.../80222.dat

Don't forget the subfiles, and to place them in the "unofficial/parts/s"-folder

[Nathan S]

Now on the Part Tracker



https://www.ldraw.org/cgi-bin/ptdetail.c.../80222.dat

Don't forget the subfiles, and to place them in the "unofficial/parts/s"-folder

Thank you very much.