(2022-08-27, 20:05)Nathan S Wrote: [ -> ]No takers?
This one is more difficult. I need to have the part and study the dimensions.
(2022-08-27, 21:07)Magnus Forsberg Wrote: [ -> ]This one is more difficult. I need to have the part and study the dimensions.
No doubt. I was hoping the new 1874 was going to be similar, but no similar angles from what I can see. The only thing I can see similar is that 18973 does seem to be the same angle as the center four studs width of 80222.
(2022-08-27, 21:07)Magnus Forsberg Wrote: [ -> ]This one is more difficult. I need to have the part and study the dimensions.
This part is in LEGO instructions. But not home to extract it😁
(2022-08-28, 10:43)Philippe Hurbain Wrote: [ -> ]This part is in LEGO instructions. But not home to extract it😁
You can send it to me, when you got it.
(2022-08-28, 18:58)Magnus Forsberg Wrote: [ -> ]You can send it to me, when you got it.
Sure, but may be long... Perhaps Gerald would be faster 😁
gett back to the full environment again :-)
Here is the raw part, with one side having cond lines only (coversion created the edge lines)
I played around with the TEXMAP for the patterned version but never made the part itsef ready for the PT