Strange line artifact part 57783?

[Jaco van der Molen]

While making a model using part 57783.dat in transparent I noticed a strange reddish line artifact when looking at it a certain angle (in LDCad).
Is that normal or is it an error in the part or rendering in LDCad?
Looking at it from another angle it is gone.

   

[Magnus Forsberg]

Is that normal or is it an error in the part or rendering in LDCad?

No, there are some red condlines in the subfile, 57783s01. It's an error.

[Travis Cobbs]

No, there are some red condlines in the subfile, 57783s01. It's an error.

For what it's worth, they show up in red in LDView also. If you enable "Show all" for conditional lines in LDView, you can easily see that there are two red ones on each side.

[Jaco van der Molen]

For what it's worth, they show up in red in LDView also. If you enable "Show all" for conditional lines in LDView, you can easily see that there are two red ones on each side.

OK, @Magus: can you correct this?

[Gerald Lasser]

OK, @Magus: can you correct this?

When it is recycled, the area in question shall be replaced by a CYLI

PS, interestingly this is a pretty old part and the issue just gets noticed now :-)

[Magnus Forsberg]

OK, @Magus: can you correct this?

Done, and in the mail to Admin.

[Magnus Forsberg]

A corrected, and reworked file and subfiles, are now on the Part Tracker.

https://www.ldraw.org/cgi-bin/ptdetail.c.../57783.dat

[Jaco van der Molen]

A corrected, and reworked file and subfiles, are now on the Part Tracker.

https://www.ldraw.org/cgi-bin/ptdetail.c.../57783.dat

Thanks all