[Complete] Technic Ring ⌀=11L, inner ⌀=9L

[SNIPE]

Hi,

I'm not sure if its too early to get this part as it does not have an official part number/ID yet

It's outer diameter looks to be 11L, its inner diameter looks to be 9L and its thickness is 1L.

It is the new technic ring that comes in set 41686, it looks fairlyy easy to make luckily, here is a picture


And here is a 360 degree view: https://youtu.be/EsVsxQWKfkk

[Gerald Lasser]

Hi,

I'm not sure if its too early to get this part as it does not have an official part number/ID yet

It's outer diameter looks to be 11L, its inner diameter looks to be 9L and its thickness is 1L.

It is the new technic ring that comes in set 41686, it looks fairlyy easy to make luckily, here is a picture


And here is a 360 degree view: https://youtu.be/EsVsxQWKfkk

Yes, that is an interesting part, i do habe two Friends Sets for review, but unfortunately not this one. I did a draft already, can upload here. 
Radius to the centre of the connhole is 5 studs

[SNIPE]

Yes, that is an interesting part, i do habe two Friends Sets for review, but unfortunately not this one. I did a draft already, can upload here. 

Yes please!.

Thanks, Snipe.

[Gerald Lasser]

Here's the draft! Note that there is a liftarm in as a helper.

I can't finish it within the next four days. So if anybody, go ahead.

[Philippe Hurbain]

Here's the draft! Note that there is a liftarm in as a helper.

I can't finish it within the next four days. So if anybody, go ahead.

I'll do!

[Philippe Hurbain]

I'll do!

Here is the completed part. Don't forget to get new primitives, now on PT.

[SNIPE]

Here is the completed part. Don't forget to get new primitives, now on PT.

Thanks.

[Mark Kennedy]

brickset list the part number as 77107

https://brickset.com/parts/design-77107

[Philippe Hurbain]

brickset list the part number as 77107

https://brickset.com/parts/design-77107

Thanks. Now on PT...
https://www.ldraw.org/cgi-bin/ptdetail.c.../77107.dat