LDView crash


LDView crash
#1
I am trying to load Datsville:

https://github.com/mjhorvath/Datsville/t...lle_source

The program simply crashes silently to desktop while loading the model. No error message or log file as far as I can tell.

LDView 4.3
Reply
RE: LDView crash
#2
(2021-04-13, 17:20)Michael Horvath Wrote: I am trying to load Datsville:

https://github.com/mjhorvath/Datsville/t...lle_source

The program simply crashes silently to desktop while loading the model. No error message or log file as far as I can tell.

LDView 4.3

I suspect it's running out of memory. I was able to open it with a 4.4 beta on my Mac, but Mac has 32 GB of RAM. Also, even though I could open the model, it was basically unusable (many seconds per frame, instead of frames per second).
Reply
RE: LDView crash
#3
(2021-04-13, 22:54)Travis Cobbs Wrote: I suspect it's running out of memory. I was able to open it with a 4.4 beta on my Mac, but Mac has 32 GB of RAM. Also, even though I could open the model, it was basically unusable (many seconds per frame, instead of frames per second).

Do you mean video RAM or system RAM? I have 16GB system RAM and I did not see usage spike very high. Normally I get between 1 and 2 FPS.
Reply
RE: LDView crash
#4
(2021-04-14, 5:06)Michael Horvath Wrote: Do you mean video RAM or system RAM? I have 16GB system RAM and I did not see usage spike very high. Normally I get between 1 and 2 FPS.

I kind of meant system RAM (hence mentioning it working on my 32GB system), but video RAM could also cause problems. You might try setting the "Memory usage" setting to "Low" if you have not already done that, and also enabling Low quality studs. Note that setting memory usage to low should decrease both system and video RAM usage.
Reply
RE: LDView crash
#5
(2021-04-14, 18:05)Travis Cobbs Wrote: I kind of meant system RAM (hence mentioning it working on my 32GB system), but video RAM could also cause problems. You might try setting the "Memory usage" setting to "Low" if you have not already done that, and also enabling Low quality studs. Note that setting memory usage to low should decrease both system and video RAM usage.

Does using the "Low" setting also decrease the framerate? It seems I am getting considerably lower FPS now than a few days ago. Though maybe something in the model changed.
Reply
RE: LDView crash
#6
(2021-04-15, 0:05)Michael Horvath Wrote: Does using the "Low" setting also decrease the framerate? It seems I am getting considerably lower FPS now than a few days ago. Though maybe something in the model changed.

It would be expected to reduce the framerate on typical models. On extremely large models, it's very system-dependent.
Reply
RE: LDView crash
#7
The problem ended up being that I turned edge lines on. Edge lines + geometry = too much for my PC to handle. I turned edge lines off and the model was able to load again. Probably GPU RAM.
Reply
« Next Oldest | Next Newest »



Forum Jump:


Users browsing this thread: 1 Guest(s)