Existing Part Edit Requests


RE: Existing Part Edit Requests
#38
>I was planning to make two subfiles one with solid and one with hollow studs that will share another subfile (3684s02).

That IMHO would be too complicated.
The studs are in the main file usually to prevent that they get a mirrored logo.
The usual approach is to put the symmetric portion of a part into a subfile,
and then use that one both from the solid and hollow stud version.
The solid stud version then again adds its studs in its main file,
and the hollow stud version adds its studs in its main file.
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Existing Part Edit Requests - by Tim Gould - 2011-12-31, 2:02
Re: Existing Part Edit Requests - by Steffen - 2011-12-31, 15:30
Re: Minifig leg is wrong - by Nils Schmidt - 2015-11-22, 18:15
Re: Minifig leg is wrong - by Chris Dee - 2015-11-22, 21:02
Re: Minifig leg is wrong - by Nils Schmidt - 2015-11-23, 6:06
Re: Minifig leg is wrong - by Chris Dee - 2015-11-23, 21:44
Wrong part number - by Christoph Mierowski - 2014-06-08, 16:55
Re: Wrong part number - by Willy Tschager - 2014-06-08, 19:27
RE: Existing Part Edit Requests - by Steffen - 2016-12-27, 18:22
RE: Existing Part Edit Requests - by Steffen - 2018-03-27, 22:08
Minifig Hand 3820.dat - by Gerald Lasser - 2018-09-14, 16:36
RE: Minifig Hand 3820.dat - by Willy Tschager - 2018-12-18, 20:47
RE: Minifig Hand 3820.dat - by Gerald Lasser - 2018-12-18, 23:34
RE: Minifig Hand 3820.dat - by Travis Cobbs - 2018-12-19, 1:42
RE: Minifig Hand 3820.dat - by Travis Cobbs - 2018-12-19, 20:11
Fix for 4x4 dish - by Gerald Lasser - 2019-05-27, 10:25
RE: Fix for 4x4 dish - by Willy Tschager - 2019-05-27, 10:57
RE: Fix for 4x4 dish - by Philippe Hurbain - 2019-05-27, 11:17
RE: Fix for 4x4 dish - by Gerald Lasser - 2019-05-27, 12:15
Snowshoes - by Gerald Lasser - 2019-06-26, 11:43
RE: Snowshoes - by Philippe Hurbain - 2019-06-26, 15:12
RE: Snowshoes - by Gerald Lasser - 2019-06-26, 21:47

Forum Jump:


Users browsing this thread: 1 Guest(s)