Parts we are Working on - Part Deux


Error in DatHeader or in the texmap specifications?
#89
(2020-07-19, 21:16)Magnus Forsberg Wrote: However, DatHeader goes into a frenzie of error messages about  "TEXMAP END before TEXMAP FALLBACK" and "TEXMAP END before surface declared". I guess it's two messages for every line it considers to be an error.
(The same thing happens on 6092p01.dat)

To clarify.
These messages comes from the program. They are not part of a review given in the program.
If I, after the last message try to view the part, the program will crash, and shuts down.
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Brick rounded 3 x 3 - by Gerald Lasser - 2019-12-31, 16:46
45706 - Trainfront - by Gerald Lasser - 2020-02-28, 23:19
RE: 45706 - Trainfront - by Gerald Lasser - 2020-03-04, 23:04
RE: 45706 - Trainfront - by Gerald Lasser - 2020-03-05, 6:52
Minion Progress! - by Gerald Lasser - 2020-05-28, 20:10
RE: Minion Progress! - by Magnus Forsberg - 2020-05-28, 22:00
RE: Minion Progress! - by Vincent Messenet - 2020-05-29, 12:50
Mario plates - by Philippe Hurbain - 2020-06-16, 11:23
RE: Mario plates - by Philippe Hurbain - 2020-06-17, 13:15
Error in DatHeader or in the texmap specifications? - by Magnus Forsberg - 2020-07-20, 6:25
RE: Ghostbuster Ecto Windscreen - by SNIPE - 2020-11-07, 7:50
RE: Parts we are Working on - Part Deux - by Bruno Altmann - 2020-11-28, 22:32
RE: Parts we are Working on - Part Deux - by Bruno Altmann - 2020-11-29, 16:45
RE: Parts we are Working on - Part Deux - by Bruno Altmann - 2020-12-07, 1:04
Parts from 75300 and 75301 - by Gerald Lasser - 2020-12-05, 15:09
Escalator Part 69900 - by Gerald Lasser - 2021-02-06, 10:00
76776 - by Gerald Lasser - 2021-07-02, 15:58

Forum Jump:


Users browsing this thread: 1 Guest(s)