LDCad 1.6 suggestions/plans


Re: LDCad 1.6 suggestions/plans
Merlijn Wissink Wrote:I just remembered a feature I'd like to see in LDCad. I believe I talked about this one earlier too: mirror building. Just like in SR3D Builder. Where you set up a mirror where you like, and then the software mirrors on side B what you're placing on side A.
I have been thinking about that but I'm probably going the cheap route and only offer a selection based axis flip. Problem is there might be different mirrored part versions for the different axis' but I might be overthinking that.

The basic flipping can even be done with the new macro scripting feature. But an list of mirrored parts would probably work better combined with a integrated feature.
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Re: LDCad 1.6 ROTSTEP feedback - by TestOne - 2016-02-25, 22:56
Re: LDCad 1.6 suggestions/plans - by Roland Melkert - 2016-03-09, 19:21
RE: LDCad 1.6 suggestions/plans - by Kai - 2016-05-23, 18:48
RE: LDCad 1.6 suggestions/plans - by Art - 2016-08-11, 12:56
RE: LDCad 1.6 suggestions/plans - by Art - 2016-08-12, 7:29
RE: LDCad 1.6 suggestions/plans - by Karen M - 2017-10-24, 10:28

Forum Jump:


Users browsing this thread: 8 Guest(s)