Help converting -all- .dat parts to fbx/obj/stl/usd/anyConventionalFileFormat


RE: Help converting -all- .dat parts to fbx/obj/stl/usd/anyConventionalFileFormat
#10
(2023-06-23, 17:13)Travis Cobbs Wrote: Try doing an STL export from the LDView UI, then go to the export options and check the units. Choose and appropriate unit and export to verify. The command line should use the most recently selected units from LDView UI.

That worked, thanks so much.
Reply
« Next Oldest | Next Newest »



Messages In This Thread
RE: Help converting -all- .dat parts to fbx/obj/stl/usd/anyConventionalFileFormat - by Kuemmerle - 2023-06-24, 0:28

Forum Jump:


Users browsing this thread: 2 Guest(s)