Existing Part Edit Requests

[Philippe Hurbain]

The axleholes do, but bars stop at 1L, however LDCAD is allowing them to go 2L in.
So we need to make the barhole fractionally smaller and cap the axle hole off, 2L axle joiners do this fine.

There's no need to change the LDraw part, you only need to define proper connectivity for it (axle holes work by inheritance, but they need an axlehole stop)

I also have added snapping to a few parts that had it missing, I will add them on the tracker once I get submit privileges

The tracker only defines geometry, for snapping information you need to add them to LDCad shadow library Github: https://github.com/RolandMelkert/LDCadShadowLibrary