(2019-11-24, 2:09)N. W. Perry Wrote: Hmm, well I'm definitely stuck on authoring any complex new parts for now, but I didn't run into any great difficulty with stickers. I've used a couple of different methods, both involving Studio Part Designer. For set 5550 I applied patterns directly to the parts that are meant to receive stickers. Then I realized that a bona-fide sticker part should be its own thing, made up of a box primitive with a pattern applied to it, so I did that for the "data sheet" sticker in set 7181. (I've attached both files—would either of these be acceptable in the OMR?)
Attached to this post? Nothing is listed. But I did the 7181 sticker already:
https://www.ldraw.org/cgi-bin/ptdetail.c...41698a.dat