RE: Gerald's Parts and Pieces Thread
2019-06-06, 20:58 (This post was last modified: 2019-06-06, 21:26 by Gerald Lasser.)
2019-06-06, 20:58 (This post was last modified: 2019-06-06, 21:26 by Gerald Lasser.)
Here are the files, I checked if I may have set the wrong part-type, but all are sub-parts...
I just tried to render 10312, the big bubble canopy which I did as well and I split also the top surface into four. I get the same seams...
I tried to inline the part and the result got worse:
A last try was to have the original generated from the CSG tool and take it "as is" (plus cond-lines), that looked quite perfect:
Dou you think it has to do with the quad winding when the sub-part is inserted and mirrored? That is the only thing I can imagine
I just tried to render 10312, the big bubble canopy which I did as well and I split also the top surface into four. I get the same seams...
I tried to inline the part and the result got worse:
A last try was to have the original generated from the CSG tool and take it "as is" (plus cond-lines), that looked quite perfect:
Dou you think it has to do with the quad winding when the sub-part is inserted and mirrored? That is the only thing I can imagine