yes that was the error - I tried a model with 2 16x16 and one 16x32 baseplate and it does crash when I set the curve quality above the 6 notch (seen from left)....
LDView Bug
« Next Oldest | Next Newest »
| Messages In This Thread |
|
LDView Bug - by Christoph Mierowski - 2012-01-15, 17:33
Re: LDView Bug - by Jean-Philippe Ouellet - 2012-01-15, 18:33
Re: LDView Bug - by Travis Cobbs - 2012-01-16, 21:36
Re: LDView Bug - by Tim Gould - 2012-01-17, 21:19
Re: LDView Bug - by Travis Cobbs - 2012-01-17, 6:21
Re: LDView Bug - by Travis Cobbs - 2012-01-17, 17:24
Re: LDView Bug - by Christoph Mierowski - 2012-01-18, 18:09
Re: LDView Bug - by Travis Cobbs - 2012-01-19, 5:09
Re: LDView Bug - by Christoph Mierowski - 2012-01-19, 19:22
Re: LDView Bug - by Steffen - 2012-01-19, 20:40
Re: LDView Bug - by Travis Cobbs - 2012-01-19, 21:07
Re: LDView Bug - by Steffen - 2012-01-19, 21:24
Re: LDView Bug - by Christoph Mierowski - 2012-01-20, 15:23
Re: LDView Bug - by Travis Cobbs - 2012-01-19, 21:04
Re: LDView Bug - by Philippe Hurbain - 2012-01-20, 7:25
|
Users browsing this thread: 2 Guest(s)