Existing Part Edit Requests

[Max Martin Richter]

I personally think that the new one closes too far.

You think it is still closing too far?
I didn't explain the picture, new one is in the back, so it is wider.

Measuring the hand, the outer diameter could be slightly larger, by approx .5 LDU. However to keep compatibility at max, i.e. the hand can fit into a stud4, the outer diameter shall be kept.

This compatibility issue raises another point:
- The hand can fit into a stud4 only without having a grip on a bar
- If the hand has a grip on a bar, it does not fit into an anti-stud.

However, I would avoid having to use two different hands? What do you think?

I like your solution, but I'll need to check against a real part.

As LDraw parts are not flexible as the real parts and therefore several building options will result in collisions anyway, I would go with just one hand model.

/Max