RE: Gerald's Parts and Pieces Thread
2018-05-06, 14:02 (This post was last modified: 2018-05-06, 18:37 by Gerald Lasser.)
2018-05-06, 14:02 (This post was last modified: 2018-05-06, 18:37 by Gerald Lasser.)
I did part 35700 from the Series 18 Figs and based it on 61780.
When doing the measurements they were slightly off, so I have made three versions, as seen in th epicture:
a) Yellow, based on the pure 61780 design (low line cout, just 47)
b) Orange, proper sized fingers for stacking (64 lines in subfile, plus 104 lines -> optimize to 64 in main Sub, 15 in finger sub, 60 in main file)
c) exact replica with quarter cutouts on the fingers (64 in main sub, 60 in finger sub, 68 in final file)
I would go for (b), what do you think?
When doing the measurements they were slightly off, so I have made three versions, as seen in th epicture:
a) Yellow, based on the pure 61780 design (low line cout, just 47)
b) Orange, proper sized fingers for stacking (64 lines in subfile, plus 104 lines -> optimize to 64 in main Sub, 15 in finger sub, 60 in main file)
c) exact replica with quarter cutouts on the fingers (64 in main sub, 60 in finger sub, 68 in final file)
I would go for (b), what do you think?