(2017-12-28, 22:43)Magnus Forsberg Wrote: As being the author of 15712, no. How does it differ? I don't understand.
The surface, which is currently at Y=0, is in real life at Y=0.5
I made a mock up for the part I wanted to author and built a holder with the clips from real parts. It struck me that I had quite a big gap with the real thing where there was non in the digital parts.
You barely notice it when you place them in a MOC, but using them as a 'measuring instrument' you notice the difference between the old and the new part.
My calipers tell me the old one is 3.2 mm whereas the new one is just 3 mm. I need to check more of them tomorrow.