(2017-01-27, 19:16)Miriana Wrote: I've 1.5 verision not 1.6 beta.1.5 has the bendable tube too.
Are tutorial on internet to use ldcad?
Tutorial is on my site:
http://www.melkert.net/LDCad/docs/basicEdit
Help with "curve" a part
« Next Oldest | Next Newest »
| Messages In This Thread |
|
Help with "curve" a part - by Miriana - 2017-01-26, 10:30
RE: Help with "curve" a part - by Gerald Lasser - 2017-01-26, 12:25
RE: Help with "curve" a part - by Philippe Hurbain - 2017-01-26, 13:45
RE: Help with "curve" a part - by Roland Melkert - 2017-01-26, 18:19
RE: Help with "curve" a part - by Miriana - 2017-01-26, 20:11
RE: Help with "curve" a part - by Roland Melkert - 2017-01-26, 20:28
RE: Help with "curve" a part - by Miriana - 2017-01-27, 19:16
RE: Help with "curve" a part - by Roland Melkert - 2017-01-28, 22:51
RE: Help with "curve" a part - by Miriana - 2017-01-30, 10:01
|
Users browsing this thread: 1 Guest(s)