RE: Existing Part Edit Requests
2016-12-27, 18:22 (This post was last modified: 2016-12-27, 18:22 by Steffen.)
2016-12-27, 18:22 (This post was last modified: 2016-12-27, 18:22 by Steffen.)
>I was planning to make two subfiles one with solid and one with hollow studs that will share another subfile (3684s02).
That IMHO would be too complicated.
The studs are in the main file usually to prevent that they get a mirrored logo.
The usual approach is to put the symmetric portion of a part into a subfile,
and then use that one both from the solid and hollow stud version.
The solid stud version then again adds its studs in its main file,
and the hollow stud version adds its studs in its main file.
That IMHO would be too complicated.
The studs are in the main file usually to prevent that they get a mirrored logo.
The usual approach is to put the symmetric portion of a part into a subfile,
and then use that one both from the solid and hollow stud version.
The solid stud version then again adds its studs in its main file,
and the hollow stud version adds its studs in its main file.