RE: LDCad 1.6 Alpha 4 (win+linux)
2016-10-12, 4:24 (This post was last modified: 2016-10-12, 4:28 by Willy Tschager.)
2016-10-12, 4:24 (This post was last modified: 2016-10-12, 4:28 by Willy Tschager.)
Coyp and paste doesn't work as expected in the source window:
* Select and copy say two parts
* Select a part and paste
* "Select the source insertion point"
* Go to the very bottom and click into the empty space (since it is the very end where I wanna insert my part)
* Apparently nothing has happened. No part shows up. Before it comes visible you have to scroll upwards and then down again. Just then the list gets updated. BTW the same happens when you add a STEP. The command shows up only after you have scrolled in the source window. The funny thing is CTRL+D immediately updates the source window.
w.
* Select and copy say two parts
* Select a part and paste
* "Select the source insertion point"
* Go to the very bottom and click into the empty space (since it is the very end where I wanna insert my part)
* Apparently nothing has happened. No part shows up. Before it comes visible you have to scroll upwards and then down again. Just then the list gets updated. BTW the same happens when you add a STEP. The command shows up only after you have scrolled in the source window. The funny thing is CTRL+D immediately updates the source window.
w.
LEGO ergo sum