LPub3D - page layout on multistep pages
2016-01-20, 14:37 (This post was last modified: 2016-02-09, 9:31 by Jaco van der Molen.)
2016-01-20, 14:37 (This post was last modified: 2016-02-09, 9:31 by Jaco van der Molen.)
When I make instructions with LPub3D everything is fine as long as I use one step per page.
However, when I include more than one step on a page several things get out of control
However, when I include more than one step on a page several things get out of control
- The steps cling together at the vertical centre of the page.
I have found out that using 0 !LPUB RESERVE 0.1 will help me separate them, but ideally I would want the first step to start at the same location it would be if it was a single step on a page.
.
- The steps cling together at the horizontal centre of the page.
I have not found a way to make PLIs stay on the same (horizontal) spot between pages (e.g. always at 2cm from the left margin). Instead they dance around the page depending on the width of the view of the model