The part does not exist without patterns at the moment.
I uploaded the 18675.dat without patterns and broke it down to a parent without top (s00) and two sub-files for the rim, s01 which is 1/8 without the handle and s02 with half of the handle.
If I would use the same base for s01 and s02 I would need another subfile as s01 needs different edge lines, any opinion?
Origin: I think it should sit at the 0 plane? Or shall it be touching the 0 plane with its top?
I uploaded the 18675.dat without patterns and broke it down to a parent without top (s00) and two sub-files for the rim, s01 which is 1/8 without the handle and s02 with half of the handle.
If I would use the same base for s01 and s02 I would need another subfile as s01 needs different edge lines, any opinion?
Origin: I think it should sit at the 0 plane? Or shall it be touching the 0 plane with its top?