[Complete] Small Sail

[Christian Maglekær]

Hi there.
Are there someone who can make this, or are working on this type of sailing?

sailbb30 sailbb19 sailbb26


The pattern has is not important at this stage, for my used

[Takeshi Takahashi]

I'd also like to make request for these sails for creating OMR sets 6057, 6261 and 6277.
The part number is u767 and they are three existing print variants.
sailbb19 -> u767p40
sailbb26 -> u767p30
sailbb30 -> u767p31
http://peeron.com/inv/parts/x767px1

Plain part (flat and formed) is sufficient, as I will try to do patterning them by myself.

[Philippe Hurbain]

I'd also like to make request for these sails for creating OMR sets 6057, 6261 and 6277.
The part number is u767 and they are three existing print variants.
sailbb19 -> u767p40
sailbb26 -> u767p30
sailbb30 -> u767p31
http://peeron.com/inv/parts/x767px1

Plain part (flat and formed) is sufficient, as I will try to do patterning them by myself.

Blank flat version is done, https://www.ldraw.org/cgi-bin/ptdetail.c...s/u767.dat
Also attached an undistorted image of px1 for patterning

[Philippe Hurbain]

First formed shape now on PT:

https://www.ldraw.org/cgi-bin/ptdetail.c...767c01.dat

[Takeshi Takahashi]

First formed shape now on PT:

https://www.ldraw.org/cgi-bin/ptdetail.c...767c01.dat

Thanks very much!!
Fit check is here: https://forums.ldraw.org/thread-26632-po...l#pid47349

I think the sail surface is clearing the stud of 4733, so the stud edge should be a rendering error.

I'll make the print after the requested part 3068bpb2007 completed.

[Takeshi Takahashi]

First flat print is done!!
https://www.ldraw.org/cgi-bin/ptdetail.c...767p01.dat

Now started this formed part

[Philippe Hurbain]

Now started this formed part

Good luck 😁

[Philippe Hurbain]

A new shape...

https://www.ldraw.org/cgi-bin/ptdetail.c...767c02.dat

[Philippe Hurbain]

Third and last shape on PT!

https://www.ldraw.org/cgi-bin/ptdetail.c...767c03.dat

[Takeshi Takahashi]

Third and last shape on PT!

https://www.ldraw.org/cgi-bin/ptdetail.c...767c03.dat

Thanks very much!! I'll check them.

[Takeshi Takahashi]

Finally the first printed sail has been done!!
https://www.ldraw.org/cgi-bin/ptdetail.c...p01c01.dat

   

[Orion Pobursky]

That part is amazing! Well done.

[Takeshi Takahashi]

Fit check for set 6261 is OK!!
Thanks, I'll start creating print.

   

[Takeshi Takahashi]

Fit check for set 6261 is OK!!
Thanks, I'll start creating print.

The second print is done!!
https://www.ldraw.org/cgi-bin/ptdetail.c...p02c02.dat