Is it possible to invert a pattern?
2012-11-10, 20:42 (This post was last modified: 2012-11-12, 19:06 by Michael Heidemann.)
2012-11-10, 20:42 (This post was last modified: 2012-11-12, 19:06 by Michael Heidemann.)
In the attached model, the red piece has the arrow pointing backward, and I'd like it pointing forward. Is it possible without creating a new part?
I could just multiply by "-1" the appropriate dimension, but that would be unphysical, causes problems in LDCad and would invert the stud logos in some case (in POV-Ray, for instance). It works with LDView, though.
I could just multiply by "-1" the appropriate dimension, but that would be unphysical, causes problems in LDCad and would invert the stud logos in some case (in POV-Ray, for instance). It works with LDView, though.