Hello!
I'm very new and definitely not versed in this community, please disregard my ignorance and naivity as a noob.
A story: I build the 6398 Police HQ in Studio for nostalgia; upon rendering it the blue webbed dish looked a tiny bit angular, lacking angular resolution. I dig deep, how parts are made, how this LDraw works, tried LD Part Editor, used spreadsheets and ultimately "updated" the 4285s01.dat sub-part. I tried my best to keep CCW orientation. There are minor coplanarity issues with it (can't spot it on renders) and I can't comprehend command line 5, so I did not touch those.
If someone has the time to take look at it, have the knowledge and will to correct it (if needed) would be nice, especially if this could become an official part later on.
Part attached to this post.
I'm very new and definitely not versed in this community, please disregard my ignorance and naivity as a noob.
A story: I build the 6398 Police HQ in Studio for nostalgia; upon rendering it the blue webbed dish looked a tiny bit angular, lacking angular resolution. I dig deep, how parts are made, how this LDraw works, tried LD Part Editor, used spreadsheets and ultimately "updated" the 4285s01.dat sub-part. I tried my best to keep CCW orientation. There are minor coplanarity issues with it (can't spot it on renders) and I can't comprehend command line 5, so I did not touch those.
If someone has the time to take look at it, have the knowledge and will to correct it (if needed) would be nice, especially if this could become an official part later on.
Part attached to this post.