[Complete] bionicle g2 uniter body pieces

[Jeff Jones]

i have a request for the following pieces to be added



24190 Large Figure Torso Skeletal with Ball Joint and Gear Hips / Waist / Bottom shorturl.at/dHQY2
[attachment=10562]
24189 Large Figure Torso Skeletal Connector with 2 Ball Joint shorturl.at/dgDE5
[attachment=10561]

[Jeff Jones]

heres a pic of the bottom of the upper torso piece 
  images.jpg (Size: 4.49 KB / Downloads: 206)

i think the gear at the bottom has 14 teeth

[Jeff Jones]

i made a rough version of the torso piece in part designer

[Magnus Forsberg]

i made a rough version of the torso piece in part designer

Your mock-up is to short.

I can't promise anything, but I have started working on these ...
Do you have this part?

       

[Jeff Jones]

Your mock-up is to short.

I can't promise anything, but I have started working on these ...
Do you have this part?

unforuntabl;ey no i dont have piece but heres a bunch of refernce images and also the gear at the bottom of the torso piece is different with i think 14 gear teeth

[Rene Rechthaler]

shouldnt the end balls be the bowlball.dat ones? and is the big pin joint the same as the one from the technic wheel hubs?

[Jeff Jones]

shouldnt the end balls be the bowlball.dat ones? and is the big pin joint the same as the one from the technic wheel hubs?

yeah the big pin on the pelvis is similar to the one from the technic wheel hubs

[Rene Rechthaler]

similar or same? can they be mixed (both ways)?
and for the "pelvis": is that a double length pinhole? with middle stop for pins? as far as I can see from the sets using it, its supposed to be used with a 12T bevel gear
--> if the partial gear from the top is a 20T gear, are the teeth aligned or shifted one half tooth to be inline with the bevel?

[Gerald Lasser]

some Brickshelf stuff:
https://brickshelf.com/gallery/jadecrane...312008.jpg
https://brickshelf.com/gallery/jadecrane...312010.jpg

[Jeff Jones]

brickowl says the gear at the bottom of the torso has 20 teeth https://www.brickowl.com/catalog/lego-to...-z20-24190

[Rene Rechthaler]

maybe it has the shape and functionality of a 20T Bevel, but it seems that the 2 side groups of 3 are merged into one so it actually has only 14 usable teeth...

[Jeff Jones]

maybe it has the shape and functionality of a 20T Bevel, but it seems that the 2 side groups of 3 are merged into one so it actually has only 14 usable teeth...

[Magnus Forsberg]

Both parts, and some needed primitives and subfiles, are now on the part tracker.

https://library.ldraw.org/tracker/33614
https://library.ldraw.org/tracker/33613
https://library.ldraw.org/tracker/33612

      

Many areas are pure guesswork, due to lack of better images.