10307 - Eiffel Tower
2022-11-25, 14:19 (This post was last modified: 2022-11-30, 21:21 by Marc Giraudet.)
2022-11-25, 14:19 (This post was last modified: 2022-11-30, 21:21 by Marc Giraudet.)
(2022-12-03, 22:35)Marc Giraudet Wrote: Inventory OK except 1 part 37762.dat (probably another extra part). Model contain "only" 344.
Part 1927.dat remplaced by 2430.dat + 2429.dat.
In progress : Improvement on flexible parts, and check for contacts (some aren't possible to avoid). OMRization at the end.
Great model, angle calculation very hard. Du to dimension, mandatory use of 4 digit calculation.
(2022-12-04, 3:27)N. W. Perry Wrote: Oh, I'm going to build it anyway. :-)
(2022-12-04, 9:41)Marc Giraudet Wrote: Yes you must do it. 2 weeks of work. If you use LDCAd, set the round parameter to 4 minimum (I used 5). ModelFileDecCnt=3 to 4 or 5
Each floor have 2 rotation angle on 26047.dat, 1 on the stud (1st), 1 on the clip (2nd).
1 - Stud 27.7437, clip 29.2067
2 - Stud 12.8396, clip 12.2295
3int - Stud 4.096, clip 3.7481
3ext - Stud 7.3871, clip 7.0413
Flag : 45
(2022-12-03, 22:35)Marc Giraudet Wrote: Inventory OK except 1 part 37762.dat (probably another extra part). Model contain "only" 344.
Part 1927.dat remplaced by 2430.dat + 2429.dat.
In progress : Improvement on flexible parts, and check for contacts (some aren't possible to avoid). OMRization at the end.
Great model, angle calculation very hard. Du to dimension, mandatory use of 4 digit calculation.