[Complete] part request: 77765

[SNIPE]

hi,

Any updates on the part: 77765 pin 3L frictionless with end stop

I get 200 of them in 2 days so I can post pictures if needed.

I tried to make a quick and dirty DAT file myself by shifting the middle stop ring across on a regular 3L pin, but couldn't find the subfile which contained the middle stop ring, seems it was not just nested in a single level subfile so things for too hairy for my experience of making parts, and I gave up.

Thanks, Snipe

[Philippe Hurbain]

Forgot about this one... yes, please post photos of the part from various angles!

[SNIPE]

Forgot about this one... yes, please post photos of the part from various angles!

Here we go:

https://ibb.co/c2bfjTt
https://ibb.co/D4VhXjK
https://ibb.co/JHHXP3P
https://ibb.co/z59Dcv9
https://ibb.co/yykwyj8
https://ibb.co/RP10YtP

Sorry if these are no good, the camera my stupid new phone doesn't know how to focus apparently.

[Philippe Hurbain]

Sorry if these are no good, the camera my stupid new phone doesn't know how to focus apparently.

Focus is good enough
Does a lightsaber blade fit the hole on both sides? If so, to what depth? There seems to be a narrower section in the middle...

[SNIPE]

Hi,

It does indeed accept a light saber hilt and 1L either side of it with friction:
https://ibb.co/0ZMWb4y
https://ibb.co/vsn4BVY
https://ibb.co/XbWzd8Q
https://ibb.co/XknfPz9


However shorter bars such as barraki eyes do not have any friction and they fall out but this shouldn't matter for ldraw.
One caveat is that the barraki eyes fit in the opening end but the mould lines fit between the notches on the end of the pin, then it has friction.

Here it is with the mould lines inside of the slots:
https://ibb.co/S5DTQFg
And this is far in as it goes when the mould lines are not aligned with the slots:
https://ibb.co/1vpfNGT

[Philippe Hurbain]

Done: https://www.ldraw.org/cgi-bin/ptdetail.c.../77765.dat
Thanks for the photos!

[SNIPE]

thanks.