Width of 62462 and 3062b should be equal but isn't


Width of 62462 and 3062b should be equal but isn't
#1
Dear Philippe Hurbain [Philo], 

In real life these two pieces are a good fit:
[Image: 200x267.jpg]

but studio renders them like this [sorry image updated with version that is rendered with the updated version of the piece, so reference removed]



hpoort at studio forum - explained Wrote:It looks as though the outer cylinder of the connector is too small (18 LDU in stead of the 19 LDU of the round brick).

Note that neither of these numbers represent the exact size of the parts, as that would be 20 LDU minus tolerances. The tolerances used in LDraw are not the exact tolerances used by LEGO in producing these parts, but are integer approximation best suited for digital building.



Can this be fixed?
Let me know if you need more photo's, renders or files.

Thank you very much.
[color=gray]My LEGO MOC's with PDF building instructions and stop-motion animations can be found on https://rebrickable.com/users/BrickDesignerNL/mocs/[/color]
Reply
RE: Width of 62462 and 3062b should be equal but isn't
#2
Here is the updated part (also sent to admin for parts tracker)!


Attached Files
.dat   62462.dat (Size: 2.06 KB / Downloads: 3)
Reply
RE: Width of 62462 and 3062b should be equal but isn't
#3
(2021-02-14, 10:54)Philippe Hurbain Wrote: Here is the updated part (also sent to admin for parts tracker)!

Just tested it in stud.io, looks way better Smile
Thanks!
[color=gray]My LEGO MOC's with PDF building instructions and stop-motion animations can be found on https://rebrickable.com/users/BrickDesignerNL/mocs/[/color]
Reply
RE: Width of 62462 and 3062b should be equal but isn't
#4
(2021-02-14, 13:27)van der Harg Wrote: Just tested it in stud.io, looks way better Smile
Thanks!
The drawback is that it is now thicker than Technic beams. But IRL it is, so...
Reply
RE: Width of 62462 and 3062b should be equal but isn't
#5
(2021-02-14, 14:55)Philippe Hurbain Wrote: The drawback is that it is now thicker than Technic beams. But IRL it is, so...

looks a lot nicer Smile

[Image: 400x320.jpg]
(click on image to zoom)

Indeed, just tested it on a real liftarm/beam corner and indeed the 62462 is wider than the corner of a Technic beam.
Looking at the cookie piece with 62462 in studio, looks like similar to how it is in real.
[Image: 160x120.jpg]
[color=gray]My LEGO MOC's with PDF building instructions and stop-motion animations can be found on https://rebrickable.com/users/BrickDesignerNL/mocs/[/color]
Reply
RE: Width of 62462 and 3062b should be equal but isn't
#6
Similar discussion here earlier:
https://forums.ldraw.org/thread-24268-po...l#pid39418 and on
Jaco van der Molen
lpub.binarybricks.nl
Reply
« Next Oldest | Next Newest »



Forum Jump:


Users browsing this thread: 1 Guest(s)