Studs with logo?


Studs with logo?
#1
Hey,

how do we proceed with the stud and logo combinations?
I wanted to review them, but realized that there is no official decision on this topic...

edit: There is some discussion on the PT here and here.

Best,
Nils
Reply
RE: Studs with logo?
#2
(2017-12-29, 18:50)Nils Schmidt Wrote: Hey,

how do we proceed with the stud and logo combinations?
I wanted to review them, but realized that there is no official decision on this topic...

edit: There is some discussion on the PT here and here.

Best,
Nils

Thanks for starting this discussion here, Nils. This is a much better place to have that discussion than spread across several files on the Parts Tracker.
Chris (LDraw Parts Library Admin)
Reply
RE: Studs with logo?
#3
(2017-12-29, 18:50)Nils Schmidt Wrote: Hey,

how do we proceed with the stud and logo combinations?
I wanted to review them, but realized that there is no official decision on this topic...

edit: There is some discussion on the PT here and here.

I like Chris' proposal best.

w.
LEGO ergo sum
Reply
RE: Studs with logo?
#4
(2018-01-10, 7:58)Willy Tschager Wrote:
(2017-12-29, 18:50)Nils Schmidt Wrote: Hey,

how do we proceed with the stud and logo combinations?
I wanted to review them, but realized that there is no official decision on this topic...

edit: There is some discussion on the PT here and here.

I like Chris' proposal best.

w.

Since there aren't any cons we should go ahead with this.

w.
LEGO ergo sum
Reply
« Next Oldest | Next Newest »



Forum Jump:


Users browsing this thread: 1 Guest(s)