Unable to edit main model LDCad with MLCad arrow present?

[Jaco van der Molen]

Hi Roland,

Having a model with instructions that use MLCad arrows, prevents me from editing that model in LDCad?
It does load, slow, shows a big green + , then loads the model showing blue plus-signs on the studs and the anti-studs are shown in red.
Removing the MLCad arrow and loading the file again is fine.

Can this be fixed?

Jaco

[Philippe Hurbain]

This probably comes from arrow made from triangle and quads beeing included in main file - in this case LDCad treats the whole model as a part. Make the arrow a submodel and it should work.

[Jaco van der Molen]

This probably comes from arrow made from triangle and quads beeing included in main file - in this case LDCad treats the whole model as a part. Make the arrow a submodel and it should work.

Ah, ok. Right, thanks.
I usually make it an MLCad part, but I guess a submodel is better.