Shaping a minifig chain in LDCad
2016-02-05, 21:07 (This post was last modified: 2016-02-08, 8:38 by Jaco van der Molen.)
2016-02-05, 21:07 (This post was last modified: 2016-02-08, 8:38 by Jaco van der Molen.)
Hi all,
Finally I got into LDcad and learning quick.
Now I found this really nice model of a jeep by Larry Lars:
https://www.flickr.com/photos/[email protected]/
I made it digital exclusively with LDCad.
Then I made it with bricks, which was most fun because I had my own building instructions and parts list to find all bricks needed :-)
I made some minor adjustments and decided to ad a little chain at the front. See picture.
Now I want that chain made in LDCad. I've been trying a few things, but cannot get it right. See chain.mpd.
Can someone assist?
What I'd really like is it to be symetric like the real thing...
Thanks.
Finally I got into LDcad and learning quick.
Now I found this really nice model of a jeep by Larry Lars:
https://www.flickr.com/photos/[email protected]/
I made it digital exclusively with LDCad.
Then I made it with bricks, which was most fun because I had my own building instructions and parts list to find all bricks needed :-)
I made some minor adjustments and decided to ad a little chain at the front. See picture.
Now I want that chain made in LDCad. I've been trying a few things, but cannot get it right. See chain.mpd.
Can someone assist?
What I'd really like is it to be symetric like the real thing...
Thanks.
Jaco van der Molen
lpub.binarybricks.nl
lpub.binarybricks.nl